Sunday, August 14, 2016

Second Thingiverse Post / Thing I made: Whirlpool Dishwasher Part WP8268846 (AP6012267)

I successfully modeled and printed a pair of replacement basket clips for my Mom's dishwasher.

Here is the thingiverse Link:

... and the completed parts:

Installation is pretty easy.

Squeeze this clip and slide the drawer-slide stop up.

With that off, the wheels slide right off the end.

The wheels snap on to the new 3d printed brackets, and the brackets snap on to the dishwasher basket.

Note: The brackets are in the wrong spots in this picture. 

The rear brackets go in the rearmost basket hole.  The front brackets go in  the fifth hole from the front.  If you put these in the wrong hole then the basket won't slide all the way out.

My family is laughing at me for buying a $200 3d printer to make two $20 parts.  Let them laugh, one day I will rule the world.  :D

Friday, August 12, 2016

First Thingiverse Post / Thing I made: Tiny Screwdriver handle

I published my first thing on Thingiverse:

It's a small "thumbdriver" handle for 1/4" hex bits.

I am enjoying my new printer very much.

Thursday, August 11, 2016

I made a thing... Poorly: Replacement Contigo Water Bottle Button

Just before bedtime my daughter brought me her water bottle and asked if I could fix it.

The button and stem, on the right, are what release the valve so water can flow.  It's from a $7 Contigo water bottle, so no big deal.  I offered to go get another with her before school tomorrow, but the she said the magic words.  "Can you make a new one on the 3D printer?"

Yes Daughter, yes I can.

So I modeled it in Fusion 360:

Then printed it out and viola! One functional, if not very attractive, replacement water-bottle button.

Monday, August 8, 2016

I made a thing: Random Dishwasher Parts

Mom asked me if I could fix her dishwasher.  The top rack keeps falling down.

Digging in, I found the problem.  This is the upper dishrack clip/axle.

It's broken, obviously.  The little clips that are supposed to hold the wheels on are half gone.

Pricing it online, these clips are $25.00 each.  Ouch.  She needs four of them.  Cough & Sputter.

So I did what any self-respecting cheapskate would do.

No, not duct tape..  :)  I made new ones.

Here is the 3D model in Fusion 360.

And now my printer is humming away, making a new one.

I'll test fit it this weekend.  If it works/fits, I'll post the model, and the Dishwasher model/part number information so the universe can share in my delight of not paying giant piles of money to buy these.